Disassembly Instructions - Mitsubishi Electric MUZ-FH25VEHZ Service Manual

12

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
12-1. MUZ-FH25VEHZ
MUZ-FH35VEHZ
OPERATING PROCEDURE
1. Removing the cabinet
(1) Remove the screw fixing the service panel.
(2) Pull down the service panel and remove it.
(3) Disconnect the power supply and indoor/outdoor con-
necting wire.
(4) Remove the screws fixing the top panel.
(5) Remove the top panel.
(6) Remove the screws fixing the cabinet.
(7) Remove the cabinet.
(8) Remove the screws fixing the back panel.
(9) Remove the back panel.
OBH625A
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Photo 1
Photo 2
48
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE: Turn OFF power supply before disassembly.
PHOTOS
Screws of the
top panel
Screws of
the cabinet
Screw of the
cabinet
Screws of
the cabinet
Screws of
the top panel
Back
panel
Screw
of the
back
panel
Service
panel
Screws of
the terminal block
support and the
back panel
Screw of the
service panel
Direction to
remove
Hooks