If The Vehicle Is Stuck - GMC Canyon 2016 Owner's Manual

Warning (Continued)
Clear snow from the base of
the vehicle, especially any
blocking the exhaust pipe.
Open a window about 5 cm
(2 in) on the vehicle side
that is away from the wind,
to bring in fresh air.
Fully open the air outlets on
or under the instrument
panel.
Adjust the climate control
system to circulate the air
inside the vehicle and set
the fan speed to the highest
setting. See Climate
Control Systems.
For more information about CO,
see Engine Exhaust 0 218
To save fuel, run the engine for
short periods to warm the vehicle
and then shut the engine off and
partially close the window. Moving
about to keep warm also helps.
If it takes time for help to arrive,
when running the engine, push the
accelerator pedal slightly so the
engine runs faster than the idle
speed. This keeps the battery
charged to restart the vehicle and to
signal for help with the headlamps.
Do this as little as possible, to
save fuel.

If the Vehicle Is Stuck

Slowly and cautiously spin the
wheels to free the vehicle when
stuck in sand, mud, ice, or snow.
See Rocking the Vehicle to Get It
Out later in this section.
The Traction Control System (TCS)
can often help to free a stuck
vehicle. See Traction Control/
Electronic Stability Control 0 231
If TCS cannot free the vehicle, see
.
ii
Rocking the Vehicle to Get it Out
following.
Driving and Operating
Warning
If the vehicle's tires spin at high
speed, they can explode, and you
or others could be injured. The
vehicle can overheat, causing an
engine compartment fire or other
damage. Spin the wheels as little
as possible and avoid going
above 56 km/h (35 mph).
For information about using tire
chains on the vehicle, see Tire
Chains 0 311 .
ii
Rocking the Vehicle to Get
It Out
Turn the steering wheel left and
right to clear the area around the
.
ii front wheels. For four-wheel-drive
vehicles, shift into Four-Wheel Drive
High. Turn the TCS off. Shift back
and forth between R (Reverse) and
a forward gear, spinning the wheels
as little as possible. To prevent
transmission wear, wait until the
wheels stop spinning before shifting
gears. Slowly spinning the wheels in
the forward and reverse directions
203