Secure The Brackets - Chamberlain LA412 Instruction Manual

STEP 4

SECURE THE BRACKETS

POST BRACKET
The gate operator (arm) must be level.
1. Mark holes for the post bracket. Remove the clamp and the operator,
set aside.
2. Drill adequate holes in the gate post.
3. Secure the post bracket to the gate post using hardware.
GATE BRACKET
The gate operator (arm) must be level.
Some installations may require additional reinforcement be installed on
the gate.
1. Drill holes in gate (or reinforcement, if necessary) that are large
enough for the gate bracket mounting hardware.
2. Secure the gate operator to the gate using hardware (not provided).
3. Manually move the gate to verify that it opens and closes fully.
Hex Nuts
Lock
Washers
Flat Washers
Post Bracket
INSTALLATION
Welder (Optional)
Hex Bolt
Carriage Bolts
Gate Bracket
Reinforcement Area
Flat Bar
13
Hex Nut
Lock Washer
Flat Washer
Welder (Optional)
Angle
Iron
OR
Wood
OR