Cisco Hawaiian Telcom Manual page 6

Pairing Your Remote Cont.
If your device cannot be paired using this alternate method, you may need to look up
the specific code for your device.
Visit http://www.urcsupport.com/html.php?page_id=711 to find the exact code for your
specific device. Use the following codes with the following steps.
1. Press the TV mode key
2. Press and hold the Setup button until the TV Mode button blinks twice
3. Enter the code you found using the website above.
4. Press the Power button to test the TV control. If the TV turns off, set up
is complete.
5. If the TV does not turn off, repeat steps 1-5 using the next code provided.
Your Wireless Gateway
The Wireless Gateway connects with your Hawaiian Telcom TV and gives you
High-Speed Internet access. Connect your devices wirelessly or through one of the
four Ethernet ports. The Wireless Gateway settings are set to default when installed.
The default network name (labeled "SSID") and password (labeled "Wireless Network
Key") are located to the right of the barcode on the side of your Wireless Gateway.
6