Mvr Vlan; Mvr Immediate - NETGEAR M4100 Series ProSAFE Reference Manual

mvr vlan

This command sets the MVR multicast VLAN.
Default 1
Format
mvr vlan <1-4094>
Mode Global Config
no mvr vlan
This command sets the MVR multicast VLAN to the default value.
Format
no mvr vlan
Mode Global Config

mvr immediate

This command enables MVR immediate leave mode. MVR has two modes of operating with
the IGMP Leave messages: normal leave and immediate leave:
• In normal leave mode, when a leave is received, the general IGMP query is sent from a
Layer 2 switch to the receiver port, where the leave was received. Then reports are
received from other interested hosts that are also connected to that port, for example,
using hub.
• In immediate leave mode, when a leave is received, the switch is immediately
reconfigured not to forward a specific multicast stream to the port where a message is
received. This mode is used only for ports where only one client might be connected.
Default Disabled
Format
mvr immediate
Mode Interface Config
no mvr immediate
This command sets the MVR multicast VLAN to the default value.
Format
no mvr immediate
Mode Interface Config
M4100 Series ProSAFE Managed Switches
Multicast VLAN Registration Commands
222