Show Running-Config Interface; Show Sysinfo; Show Tech-Support - NETGEAR M4100 Series ProSAFE Reference Manual

• If some, but not all, of the flags in that group are enabled, the command displays
trapflags groupname flag-name.
Format
show running-config [all | <scriptname>]
Mode Privileged EXEC

show running-config interface

This command shows the current configuration on a particular interface. The interface could
be a physical port or a virtual port—like a LAG or VLAN. The output captures how the
configuration differs from the factory default value.
Format
show running-config interface {<slot/port>} | vlan <vlan-id> | lag
<lag-id>}
Mode Interface Config

show sysinfo

This command displays switch information.
Format
show sysinfo
Mode Privileged EXEC
Term Definition
Switch Text used to identify this switch.
Description
System Name Name used to identify the switch. The factory default is blank. To configure the system
name, see
System Location Text used to identify the location of the switch. The factory default is blank. To configure
the system location, see
System Contact Text used to identify a contact person for this switch. The factory default is blank. To
configure the system location, see
System Object The base object ID for the switch's enterprise MIB.
ID
System Up Time The time in days, hours, and minutes since the last switch reboot.
MIBs Supported A list of MIBs supported by this agent.

show tech-support

Use this command to display system and configuration information when you contact
technical support. The output of this command combines the output of the following
commands:
M4100 Series ProSAFE Managed Switches
snmp-server on page 491.
snmp-server
snmp-server
Utility Commands
350
on page 491.
on page 491.