Utm10 Configuration; Create A New Vlan - NETGEAR UTM10 - ProSecure Unified Threat Management Appliance Application Note

UTM10 Configuration

Create a new VLAN

Access the VLAN configuration via
Network Config, LAN settings, LAN
Setup. VLAN1 exists on the default
configuration and all the ports are
members of it.
Change VLAN1 Profile name to
Corporate by simply editing the VLAN
profile.
Click on Add... to create a new VLAN
Repeat the same process for both VLAN
20 and VLAN 30 (for administration
purposes each will have the profile name
matching the respective SSID).
Port 1 will be the only port member of
each of the new VLANs as this is the port
the Access Point will connect to.
(If required enable DHCP with a scope of
addresses within the same range as the
VLAN IP address).
Click on Apply.
After creating each VLAN the User will be
prompted with the VLAN Profiles
summary
NOTE: Although not relevant in this scenario, attention
should be dedicated to the Default VLAN concept.
Changing the Default VLAN for a Port will be equivalent to
changing the PVID of the port on for example a Netgear
switch 802.1q capable.
A port member of multiple VLANs will be instead be the
equivalent of setting an 802.1q trunk port, as long as the
default VLAN is VLAN 1.
Version 2.0