NETGEAR M4100 Series ProSAFE Reference Manual page 388

netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration
Protocol (DHCP) clients. The <type> parameter specifies the NetBIOS node type. Valid
types are:
• b-node—Broadcast
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default none
Format
netbios-node-type <type>
Mode DHCP Pool Config
no netbios-node-type
This command removes the NetBIOS node Type.
Format
no netbios-node-type
Mode DHCP Pool Config
next-server
This command configures the next server in the boot process of a DHCP client. The
<address> parameter is the IP address of the next server in the boot process, which is
typically a TFTP server.
Default inbound interface helper addresses
Format
next-server <address>
Mode DHCP Pool Config
no next-server
This command removes the boot server list.
Format
no next-server
Mode DHCP Pool Config
M4100 Series ProSAFE Managed Switches
Utility Commands
388