Custom Panel Preparation - Fisher & Paykel ActiveSmart RS90A Installation Instructions Manual

CUSTOM PANEL PREPARATION

The following drawings apply to non-Ice & Water models only. Dimensions are shown in
Metric (mm) and apply for the preparation and installation of custom door panels.
For Dwg and Dxf files of the below panel preparation download the folder on
http://thekitchentools.fisherpaykel.com
54.8
ions are shown in Metric (mm)
ions apply for the preparation and
tion of custom panels.
second panel mirror and repeat dimensions
nner bottom corner as the reference point.
nd Dxf files of the above panel
ation download the folder on
hekitchentools.fisherpaykel.com
All measurements to be made
from inner bottom corner.
For the second panel mirror
and repeat dimensions using
inner bottom corner as the
reference point.
TOP PANEL – REAR VIEW
toP PANEl – rEAr vIEw
7 CUStom door PANEl PrEPArAtIoNS
392.3
R1.25 REF
12x Pilot holes recommended for
bracket attachment.
(Do not penetrate front surface).
35
297.4
50
457.5
50
126.1
34.7
414
Handle details
Top Panel – Ensure handle is mounted 65.03 mm from inner edge of panel to the centre –
this will avoid interference with brackets.
CUSTOM PANEL PREPARATION
Bottom Panel – Ensure handle screw heads are counter sunk into back of panel to avoid
interfering with hanging bracket.
Note:
Dimensions are shown in Metric (mm)
Dimensions apply for the preparation and
installation of custom panels.
Dwg and Dxf files of the above panel
preparation download the folder on
http://thekitchentools.fisherpaykel.com
385
29.1
58.1
492
416
Bottom PANEl – rEAr vIEw
BOTTOM PANEL – REAR VIEW
R1.25 REF
10x Pilot holes recommended for bracket attachment.
(Do not penetrate front surface).
128
58.1
50
9