Setting Up The Refrigerator - Samsung SRS635SCPLS User Manual

When moving your refrigerator
To prevent floor damage, be sure the front leveling
legs are in the up position (above the floor).
Refer to "How to level the refrigerator" in the
manual on page 24.
Leg
Flooring
For proper installation, you must place this
refrigerator on a level, hard surface that is the same
height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back.
Do not wiggle it from side to side.
DA68-03281D (EN)-00.indd 18
Required Tools (Not provided)
Philips screwdriver
Screw Driver

SETTING UP THE REFRIGERATOR

Now that you have your new Refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your Refrigerator
should be fully operational.
If not, first check the power supply and electricity
source or try the troubleshooting section at the
back of this user's guide.
If you have any further questions, contact your
Samsung Electronics service centre.
1. Place the Refrigerator in an appropriate location
2. Once the Refrigerator is plugged in, make sure
3. Set the Temperature control to the coldest
4. After powering the Refrigerator, it will take a few
5. Once installation is complete, press the
6. Make sure the front side of the refrigerator is 0.6
English - 18
Flat-blade screw
(+) driver (-)
Allen wrench
5 mm
with reasonable clearance between the wall and
the Refrigerator.
Refer to installation instructions in this manual.
the interior light comes on when you open the
doors.
temperature and wait for an hour.
The Freezer will get slightly chilled and the
motor will run smoothly.
hours to reach the appropriate temperature.
You can store food and drinks in the Refrigerator
after the temperature is sufficiently cool.
dispenser lever to check if the water or the ice
is properly dispensed.
degree higher than its rear side.
Socket wrench
10 mm
15. 1. 19. 5:13