Wipers And Washers; Windshield Wipers; Autowipers - Ford TOURNEO CONNECT Owner's Manual

WINDSHIELD WIPERS

Note: Fully defrost the windshield before
switching on the windshield wipers.
Note: Make sure the windshield wipers are
switched off before entering a car wash.
Note: Install new wiper blades as soon as
they begin to leave bands of water and
smears on the windshield.
Note: Do not operate the wipers on a dry
windshield. This may scratch the glass,
damage the wiper blades or cause the wiper
motor to burn out. Always use the
windshield washers before wiping a dry
windshield.
A Single wipe
B Intermittent wipe
C Normal wipe
D High speed wipe
Note: If you press and hold the wiper lever
in position A, the wipers will continue to
wipe until you release the wiper lever.
Tourneo Connect (C4A) M1 Kombi/N1 Kombi, ET7J-19A321-AKA (CG3606en) enGBR, Edition date: 02/2014

Wipers and Washers

Intermittent Wipe
Use the rotary control to adjust the
intermittent wipe interval.
Speed Dependent Wipers
When your vehicle speed increases, the
interval between wipes will decrease.

AUTOWIPERS

Note: Fully defrost the windshield before
switching on the windshield wipers.
Note: Make sure the windshield wipers are
switched off before entering a car wash.
Note: Clean the windshield and wiper
blades if they begin to leave streaks or
smears. If that does not resolve the issue,
install new wiper blades.
Note: If you switch autolamps on in
conjunction with autowipers, low beam
headlamps will illuminate automatically
when the rain sensor activates the
windshield wipers continuously.
Wet or winter driving conditions with ice,
snow or salty road mist can cause
inconsistent and unexpected wiping or
smearing.
42
A Short wipe interval
B Intermittent wipe
C Long wipe interval