Stowing The Flat Tire - Ford TOURNEO CONNECT Owner's Manual

WARNINGS
Lug nuts are subject to change. You
must make sure that you use only
the specific lug nuts and wheels
supplied for your vehicle. If in doubt see an
authorized dealer.
Make sure there is no lubrication
(grease or oil) on the threads or the
surface between the wheel lugs and
nuts. This can cause the lug nuts to loosen
while driving.
Note: The lug nuts of alloy wheels can also
be used for the steel spare wheel for a short
time (maximum two weeks).
Note: Make sure the wheel and hub contact
surfaces are free from foreign matter.
Note: Make sure that the cones on the lug
nuts are against the wheel.
1. Install the wheel.
2. Install the lug nuts finger tight.
3. Install the optional locking lug nut key.
Tourneo Connect (C4A) M1 Kombi/N1 Kombi, ET7J-19A321-AKA (CG3606en) enGBR, Edition date: 02/2014
Wheels and Tires
4. Partially tighten the lug nuts in the
5. Lower your vehicle and remove the
6. Fully tighten the lug nuts in the
7.

Stowing the Flat Tire

Do not raise the spare wheel carrier
without the wheel attached. Damage can
occur to the winch mechanism if lowered
without a wheel attached.
Note: Do not lay alloy wheels face down
on the ground, this will damage the paint.
When stowing the flat tire use a sheet or
mat under the wheel to protect the paint.
164
sequence shown.
jack.
sequence shown. See Technical
Specifications (page 165).
Install the wheel trim using the ball of
your hand.
WARNING
Have the lug nuts checked for
tightness and the tire pressure
checked as soon as possible.