Health & Safety - Fisher & Paykel WA37T26EW Service Manual

479602
1 HEALTH & SAFETY
When servicing the Designer series Range Hood, health & Safety issues must be considered at all
times. Specific safety issues are listed below with the appropriate icon.
Electrical Safety
Ensure the mains power has been disconnected before servicing the
washer.
If the mains supply is required to be on to service the washer, make sure it
is turned off when removing any electrical component or connection to
avoid electric shock.
Electrostatic Discharge
An anti-static strap is to be used as electrical static discharge (ESD)
protection when servicing electronic components.
Good Working practices
Ensure the work area is in a tidy and orderly condition at all times so as
not to cause a hazard while service work is being completed. Always clean
and tidy the washer and work area after service is completed.
Isolate Water Supply
Turn off the water connection taps before servicing
Water Leak Check
Check for water leaks as part of the testing after the service has been
completed.
Insulation test
Megger test to check insulation
Warning: short together the phase and neutral pins on the plug so not to
damage any electronic circuitry.
Sharp Metal Edges
When working around cut sheet metal edges, use appropriate gloves or
protection to eliminate the change of receiving a laceration.
6