Mount The Charging Dock; Mount The Interface Module - Navman Lone Worker Installation Manual

2.5 Mount the Charging Dock

Choose a suitable mounting location on the dashboard, such as a spare accessory blanking
plate, where the Charging Dock will not interfere with the safe operation of the vehicle.
If a spare accessory blanking plate is available, remove this and run the USB cable through
the hole.
If a spare accessory blanking plate is NOT available, Navman Wireless recommend that
you run the USB cable between two panels on the dashboard.
Drill a hole only when this is unavoidable.
2.5.1 Interface Module Connections
Identify the connectors on the Interface Module:
Front
Antenna
Power
Back
6-Pin Input Cable

2.6 Mount the Interface Module

The Interface Module mounting location must:
NOT be visible to the lone worker or any other vehicle driver,

be a flat rigid surface where the Interface Module can be firmly secured,

be close to the Qube so that the 5-Wire Output Cable and 6-Wire Input Cable

can connect comfortably,
Charging Dock
NOT USED
NOT USED
9
Lone Worker Solution | Installation Manual
Power LED FUTURE USE
5-Pin Output Cable