Find The Qube; Mount The Antenna - Navman Lone Worker Installation Manual

CAUTION
Ensure that any holes that need to be cut in the vehicle will not weaken the vehicle
structure or compromise the safety of the vehicle or its occupants. If in doubt, consult
the vehicle manufacturer.
Consult the vehicle owner and agree on the proposed mounting locations for the
Interface Module, Antenna, and Charging Dock BEFORE cutting any holes in the vehicle.
Where holes are required, use grommets to ensure that the vehicle remains waterproof.

2.3 Find the Qube

You need to install the Interface Module close to the Qube, so find the Qube. This is
usually behind the vehicle's dash but it may be in the boot/trunk area.
Check that the cables are long enough to reach comfortably between the Qube, the vehicle
ignition loom (or fuse box) and proposed locations for the Interface Module, Antenna, and
Charging Dock which are described in the following sections.
If the cables are not long enough, you need to supply:
a 5-Core cable extension to cover the Digital Inputs/Output (see section 3.2)

between the Qube and the Interface Module
a 5-Core cable extension to connect the Antenna to the Interface Module (see

section 2.7).

2.4 Mount the Antenna

CAUTION
The Antenna must be located at least 20 cm (8") from any person to meet FCC RF
exposure requirements.
1. Sit in the driver's seat and choose a location along the top of the windscreen. The
Antenna MUST be mounted on the windscreen and within easy reach of the driver.
Note:
A suitable location is usually near to the A pillar so that the cable can be hidden
behind the interior panels.
2. Clean any dust and grease from the chosen location area.
3. Remove the backing tape from one side of the Antenna Adhesive Pad and press the
pad firmly to the windscreen.
4. Peel the backing tape from the other side of the Antenna Adhesive Pad.
5. Orient the Antenna so that the mast points DOWN and the CALL button is the right
way up, then press the back of the Antenna firmly onto the Antenna Adhesive Pad.
Lone Worker Solution | Installation Manual
8