Installation; Prerequisites; Installation Overview - Navman Lone Worker Installation Manual

2

Installation

2.1 Prerequisites

This installation process assumes that:
A Qube is already installed in the vehicle and is fully operational. If not, please

install the Qube according to its install guide BEFORE starting the Lone Worker
Solution installation. Note that the Lone Worker Solution is compatible with any
Qube that has sufficient digital I/O available. Depending on the mode used, the
Lone Worker Solution requires 2 or 4 digital inputs and 1 digital output.
The Qube already has a suitable ConEx cable installed. If not, please obtain this

cable from your Navman Wireless dealer in order to complete the Lone Worker
Solution installation.
The Qube and AVL2 are correctly configured for the Lone Worker Solution

The "Ack Back" and alerting system has been activated


2.2 Installation Overview

Navman Wireless recommend that you install the Lone Worker Solution components in the
order shown below:
Mount the Antenna, Charging Dock, and Interface Module.

Connect the Antenna to the Interface Module.

Connect the Charging Dock to the Interface Module.

Connect the Interface Module to the vehicle ignition loom (or fuse box) through

a constant 12 V battery supply.
Connect the Interface Module to the Qube.

(Optional) Connect the relay drive output to the vehicle's lights and horn.

Put the Pendant into the Charging Dock so that the Pendant's internal battery

can start to charge, ready for testing, as soon as you have connected the
Interface Module.
Test the Pendant and the Antenna.

Navman Wireless recommend that you read this entire section BEFORE starting.
Lone Worker Solution | Installation Manual
7