Table of Contents
Advertisement
allow easy access to both the front and back of the Interface Module,
be dry and not be subject to excessive vibration or excessive heat.
Mount the Interface Module at the chosen location as follows:
1. Clean any dust and grease from the chosen mounting location.
2. Remove the backing tape from one side of the Interface Module Adhesive Pad and
press the pad firmly to the chosen mounting location on the vehicle.
3. Peel the backing tape from the other side of the Interface Module Adhesive Pad.
4. Press the back of the Interface Module firmly onto the Interface Module Adhesive Pad.
5. Secure the Interface Module in place with cable ties.
2.7 Connect the Antenna to the Interface Module
1. Find the Antenna cable.
2. Push the black end into the cable port at the top of the Antenna.
3. Run the Antenna cable behind the interior panel by the A pillar, to the Interface
Module. Secure the Antenna cable tidily using wire cable ties.
4. Push the white end into the Antenna port on the front of the Interface Module. It
clicks into place.
2.8 Connect the Charging Dock to the Interface Module
1. Run the Charging Dock cable discreetly between the dashboard panels to the
Interface Module. Make sure that Charging Dock cable is flush against the surface,
with no cable loops or similar that could snag and dislodge the cable in the future.
2. Secure the Charging Dock cable using wire cable ties.
3. Push the USB connector into the USB port on the front of the Interface Module.
Lone Worker Solution | Installation Manual
10
Advertisement
Table of Contents
