Table of Contents
Advertisement
3. Press either button on the Pendant and a beep will sound. Hold the button for
approximately 1 second until a second beep is heard, then release. The Pendant then
tries to send a High Priority Alert.
4. If the High Priority Alert was sent successfully, the Pendant should receive an Alert
Acknowledgement from back office within 3 minutes. (The length of time depends on
the cellular or satellite network.)
The Interface Module beeps once and the Pendant beeps (ascending and descending)
and vibrates 3 times to confirm that your Alert has been received by back office.
The Pendant repeats this sequence once.
5. Verify with Technical Support that the event has been received.
4.5 Test the Person Down Alert Function
1. Check that you are still logged into OnlineAVL2 and, if not, log in again.
2. Exit the vehicle then throw the Pendant up in the air for at least 100 cms (3 feet). Be
sure to catch the Pendant before it hits the ground, to avoid damage to the Pendant.
The sudden movement should trigger a Person Down Alert.
3. The Pendant warbles and illuminates the green LED for 10 seconds then sends a
Person Down Alert.
4. If the Person Down Alert was sent successfully you will receive an Alert
Acknowledgement from back office.
5. Verify with Technical Support that the event has been received.
4.6 Test the Pendant Check In Function
1. Check that you are still logged into OnlineAVL2 and, if not, log in again.
2. Double press either button. The Pendant beeps once for each press then tries to send
a Check In message.
3. Verify with Technical Support that the event has been received.
4. You will not receive an Alert Acknowledgment.
4.7 Test the Antenna Alert Function
1. Hold the CALL button on the Antenna for 1 second then release.
2. The Interface Module sounds a noise to confirm that the High Priority Alert has been
sent.
3. Verify with Technical Support that the event has been received.
Lone Worker Solution | Installation Manual
15
Advertisement
Table of Contents
