Table of Contents
Advertisement
4
Commission Testing
4.1 Configuration and Activation of Lone Worker Solution
Verify with Navman Wireless Technical Support that the Qube has been correctly
configured for connection to the Lone Worker Solution.
Verify with Navman Technical Support that the "Ack Back" system has been activated
4.2 Charge the Pendant
4.3 Check the Ignition Connection
Check that the Red wire of the Main Power Harness is connected to the same main power
connection as the Qube.
4.4 Test the Pendant High Priority Alert Function
When the Pendant battery is fully charged, check that the Pendant can communicate with
OnlineAVL2 correctly as follows:
1. Park the vehicle outside, in a location with a clear view of the sky and good cellular
coverage.
Note:
If there is no cellular coverage area but the vehicle has a Q-Pro modem, any
High Priority Alerts will be sent by satellite.
2. Log into OnlineAVL2 then call the Navman Wireless Support Team for assistance with
commissioning the Lone Worker Solution for this particular vehicle.
1.
Align the Pendant with the Charging Dock, with the buttons
at the front. Push the Pendant firmly into the Charging Dock,
as shown.
The Pendant sounds and ascending/descending tone when it
has docked successfully.
2.
The RED and GREEN LEDs flash alternately once a second
while the battery is charging. This can take up to 2 hours.
3.
When the battery is charged, the GREEN LED slowly fades on
and off. The Pendant remains in a low power state until it is
removed from the Charging Dock.
Lone Worker Solution | Installation Manual
14
Advertisement
Table of Contents
