Test The Out Of Range Warning; Handover; Troubleshooting - Navman Lone Worker Installation Manual

4.8 Test the Out of Range Warning

Perform this test ONLY for a Multi-Output Wiring installation (see section 3.2.2).
1. Simulate that the Pendant has been moved out of range by unplugging the power
from the interface module.
2. After a few seconds the Pendant detects that it has lost communication with the
interface module and sounds 3 long warning beeps and vibrates 3 times. It also
flashes the RED LED twice every 20 seconds.
3. Reconnect power to simulate the Pendant moving back in range so that it returns to
normal operation – it should start to flash the green LED every 10 seconds

4.9 Handover

When you have completed all the tests and confirmed with the Navman Wireless Support
Team that the Lone Worker Solution is working correctly, please:
Lone Worker Solution User Guide
1. Leave the
by the lone worker (e.g. on the driver's seat).
2. Leave the Pendant ON and place it in the battery charger, ready for use by the lone
worker.

4.10 Troubleshooting

4.10.1 Alert or Check In Not Shown in AVL2
If an Alert or a Check In is not shown in the client, try the following:
Check that all of the cables are connected correctly and are secure.

Check that the Interface Module is connected correctly so that it is powered.

Check that the GREEN LED on the Pendant is flashing once every 10 seconds

(this shows the Pendant is paired correctly with Interface Module).
Confirm that the Qube 4 is awake with cellular communications operating

correctly by contacting the Navman Wireless Support Team and asking if the
vehicle is shown as online in OnlineAVL2 (IGN on).
Confirm with Technical support that the Qube is set up with the correct ConEx

configuration and satellite prioritisation for ConEx (if satellite modem is being
used)
4.10.2 Alert Acknowledgement is not Received
If the alert acknowledgement is not received by the Pendant, :
Check that all of the cables are connected correctly and are secure.

Verify with Technical Support that "Ack Back" is enabled.

Lone Worker Solution | Installation Manual
in the vehicle where it can be seen easily
16