Table of Contents
Advertisement
5
Configuring the System
The Lone Worker Solution should be already set up correctly for the particular customer
and installation requirements. Check with Navman Wireless Technical Support before
making any configuration changes.
5.1 To Configure the Lone Worker System
1. Ensure the Pendant is working and communicating with the vehicle
2. Press and hold both buttons for 5 seconds until you hear the ascending tones.
3. Press the lower button the required number of times to set the required configuration
setting (see below).
4. When the required number of presses have been entered, wait for the Pendant to
respond with a sequence of beeps – one for each button press.
5. The system will now adopt the new setting
5.2 Configuration Settings
The number of button presses for each config setting are as follows:
3 – Wait for application Ack (default)
4 – Do not wait for application Ack
5 – Multi Output mode
6 – Single Output mode (default)
7 – Accelerometer ON (default)
8 – Accelerometer OFF
9 – un-pair Pendant
10 – Get FW version
11 – Impact setting is 1.5G (default)
12 – Impact setting is 2.0G
13 – Impact setting is 2.5G
14 – Impact setting is 3.0G
15 – Impact setting is 3.5G
17 – Freefall detect is OFF
18 – Freefall detect is 1m
19 – Freefall detect is 2m (default)
20 – Motion detect after man down event is OFF (default)
21 – Motion detect after man down event is 5s
22 – Motion detect after man down event is 10s
23 – Return Pendant to default settings (i.e. options 7, 11, 19, 20)
Lone Worker Solution | Installation Manual
17
Advertisement
Table of Contents
