Jayco 2016 Jay Series Owner's Manual page 121

JAYCO HARD WALL MODELS
Wipe down the left front edge and the right rear edge of the trailer with isopropyl
alcohol. Ensure surfaces are dry before applying Velcro. Apply a 30 inch piece of
Velcro to the front left edge next to the trim (Pic 1) and another 30 inch piece to
the right rear edge next to the trim (Pic 2). The white strip in each photo is the
Velcro.
FRONT
Trim
1
3" Velcro strips must be installed along the frame of the trailer (Pic 3) so the
netting can be installed. It is advisable to hold the netting up in place as you
install the Velcro strips. Refer to arrows in Pic 4 on the doorside: Place 2 above
the wheel, 1 behind the wheel, 1 between the door & the wheel, 1 at the front of
the door. Two pieces will attach below the door for the step, but refer to
special instructions on next page explaining how to configure the netting at the
fold down step.
3
5 Netting
SCT HS
Velcro
Trailer Frame
SECTION 14 – SETUP & MAINTENANCE
REAR
Velcro
2
4
Refer to Pic 5: Install 6
more strips of Velcro to the
trailer frame.
Place 3 strips along the
frame from behind the
wheel to the rear of the
trailer (rear arrows), and 3
strips from in front of the
door along the frame
toward the front of the
trailer (forward arrows).
Trim
14-7