Jayco 2016 Jay Series Owner's Manual page 120

Camping trailers
Hide thumbs Also See for 2016 Jay Series:
Table of Contents

Advertisement

SECTION 14 – SETUP & MAINTENANCE
TO REDUCE THE RISK OF DEATH, PERSONAL INJURY, FIRE OR
DAMAGE:
Do not use heaters, cooking grills, camp fires, camp stoves or gas
burning lamps inside of the screen room.
Never operate generators, motorcycles, or any internal combustion
engines inside the screen room.
Close attention is necessary when used by or near children. Do not
allow children or adults to lean against the sides of the screen room.
Do not suspend electrical lights from the room's poles or allow electrical
lights to come in contact with the fabric of the screen room.
Do not modify or change the installation of the screen room.
Use the screen room only as described in the Installation & Operating
Instructions supplied in your owner's packet.
A-F
A
RAME
WNING
Attaching this screen room to your A-Frame camping trailer will allow you to
increase your living space. Use the following numbered pictorial as a general
guideline in setting up your screen room. See the screen room Installation &
Operating Instructions supplied in your owner's packet for detailed instructions on
this set up.
A second person will make the set up faster and easier.
Maintenance:
Care should be taken when setting up and putting the screen room away to avoid
tears and cuts.
Wash off any droppings or foreign matter from trees with clear water and keep
the screen room clean when putting away
Do not store your screen room if wet or damp. Mildew may form and color
transfer/bleed may occur if stored wet or damp.
If mildew is apparent, it should be treated promptly with a light solution of
soap and water. A soft brush or cloth is recommended for cleaning.
 NOTE: It will be necessary to install Velcro to your unit prior to setting up the
screen room. This step should only be necessary prior to the first time use of the
screen room.
A
V
TTACHING
ELCRO
Attach Velcro strips to the trailer. The trailer needs to be clean. Apply isopropyl
alcohol to a clean cloth. Wipe down all locations where Velcro strips will be
applied to the trailer.
The following photos will help determine where to apply these Velcro strips before
setting up the screen room.
14-6
/ S
R
CREEN
OOM
S
T
TRIPS TO
RAILER
JAYCO HARD WALL MODELS
WARNING
S
ETUP
SCT HS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents