Setting The Clock; Setting And Using The Alarms - iHome iKN95 Instruction Manual

Setting the Clock

1. Press and hold the
seconds until the clock display flashes and a beep sounds.
2. Press the – or +
setting). Make sure you set the correct AM/PM time. The AM and PM indicators
appear to the left of the display.
3. To toggle the clock display between standard 12 hour time and 24 hour ("military") time display,
press the Alarm or
4. Press the Time Set Button. The year will flash on the display.
5. Press the – or + Buttons to adjust the clock to the current.
6. Press the Time Set Button. The date will flash on the display.
7. Press the – or + Buttons to adjust the clock to the date.
8. Press the Time Set Button to confirm and exit clock setting mode. 2 beeps will confirm clock setting
is complete.

Setting and Using the Alarms

This unit features dual alarms which can be set to different times and alarm sources. Each is set in the
same way. Instructions are given as "Alarm Button"; use Alarm 1 Button or Alarm 2 Button to set
respective alarms. Alarm will sound for 1 hour until reset.
Note: Each step must be completed while display is flashing or step will time-out with any changes
saved.
1. Press and hold the Alarm Button for 2 seconds until the alarm time display and alarm icon flash. A
beep sounds.
2. Press the – or + Buttons to adjust the alarm time to the desired time (hold for rapid setting).
Make sure you set the correct AM/PM alarm time.
3. Press the Alarm Button to confirm the alarm time setting. The wake-to source will flash.
Time Set Button located on the back of the unit for 2
Buttons to adjust the clock to the current time (hold for rapid
Alarm Button while the display is flashing during time setting.
Using the
10
iKN95