iHome iKN95 Instruction Manual page 12

Setting and Using the Alarm (Continued)
4. Press the – or +
Bluetooth, radio or tone. The selected wake-up source will flash in the lower
part of the display.
Wake to Bluetooth: You will wake to the currently linked Bluetooth device. If no
Wake to Radio: Press the Alarm Button to confirm. Press the
Wake to Tone: Press the Alarm Button to confirm. Press the – or + Buttons as needed to listen to
and to select one of the four built-in wake-to tones (1 - 4). I
5. Press the Alarm Button to confirm the alarm source. The volume display will flash.
6. Press the – or + Buttons to adjust the alarm volume. Note that the alarm volume setting is stored
separately from other volume settings.
7. Press the Alarm Button to confirm the alarm settings and exit alarm setting mode. 2 beeps will confirm
alarm setting is complete. The alarm icon will remain on the display, indicating the alarm is armed.
8. When alarm is sounding, press the
and reset it come on the next day at the same time (unles settings are changed).
Previewing the Alarm and Turning the Alarm On/Off
1. Press and release the Alarm Button to view the current alarm time.
2. Press and release the Alarm Button as needed to toggle the alarm ON and OFF, indicated by the
alarm icon and a beep.
Buttons to select the desired wake to alarm source:
device is detected, the alarm will default to Tone.
to wake to, or press the – or + Buttons to tune in a desired wake to station.
If FM antenna is missing, the alarm will default to Tone.
Power Button or Alarm 1 or Alarm 2 Button to silence alarm
11
iKN95
Using the
Presets Button to select an FM preset