Setting The Clock; Setting And Using The Alarms - iHome iKT50 Instruction Manual

Setting the Clock

1. Press and hold the Sleep/Time Set Button for 2 seconds until "DST ON" flashes on
the display and a beep sounds, indicating automatic daylight saving time feature is
active and the unit will add or subtract an hour automatically at the start or end of
daylight saving time. To disable DST feature, press the – or + Buttons to toggle to
"DST OFF".
2. Press the Sleep/Time Set Button. The year will flash on the display.
3. Press the – or + Buttons to adjust the clock to the current year.
4. Press the Sleep/Time Set Button. The date will flash on the display.
5. Press the – or + Buttons to adjust the clock to the date.
6. Press the Sleep/Time Set Button. The time will flash.
7. Press the – or + Buttons to adjust the clock to the current time (hold for rapid setting).
Make sure you set the correct AM/PM time. The AM and PM indicators appear to the
left of the display.
8. Press the Sleep/Time Set Button to confirm and exit clock setting mode. 2 beeps will confirm clock
setting is complete.
TIP: To toggle the clock display between standard 12 hour time and 24 hour ("military") time display,
press the Alarm or

Setting and Using the Alarms

This unit features dual alarms which can be set to different times and alarm sources. Each is set in the same
way. Instructions are given as "Alarm Button"; use Alarm 1 Button or Alarm 2 Button to set respective
alarms. Alarm will sound for 1 hour until reset.
Note: Each step must be completed while display is flashing or step will time-out in 10 seconds with any
changes saved.
1. Press and hold the Alarm Button for 2 seconds until the alarm time display and alarm icon flash. A
beep sounds.
Alarm Button while the display is flashing during time setting.
10
K4
Using the