Advertisement
V . C O M F O R T A D J U S T M E N T S
POSITIONING BELT (OPTIONAL)
Your scooter seat may be equipped with a positioning belt that can be adjusted for operator comfort. See
figure 14. The positioning belt is designed to help support the operator so that he or she does not slide
down or forward in the seat. The positioning belt is not designed for use as a restraining device.
WARNING! The positioning belt should be secured at all times. Never allow the
positioning belt to hang or drag on the floor as it may become entangled.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the bottom of the seat base. See figure 13.
3. Use a wrench to remove the two rear bolts on the outermost part of the seat frame.
4. Insert the bolt through the appropriate ends of the positioning belt and then reinstall the bolts back into
the seat frame.
5. Tighten the bolts.
To adjust the positioning belt for operator comfort:
1. Align the two sides of the belt placing the looped-end side directly above the courser side ("hook") of
the opposite belt. Press firmly together to fasten. See figure 14.
To release the positioning belt:
1. Grasp the looped-end side of the belt and pull up to detach from the other side of the belt.
MANDATORY! Make sure the positioning belt is properly secured to the scooter and is
adjusted for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose parts or damage, including tears,
worn spots, bent hardware, or damaged latch mechanisms, dirt or debris, before each
use of the scooter. If you discover a problem, contact your authorized Provider for
maintenance and repair.
Figure 13. Positioning Belt Bolts
ES2
Figure 14. Positioning Belt
19
Hide quick links:
Advertisement
