Brother HL-2250DN Service Manual page 109

(4) Remove the Screw pan (S/P washer) M3.5x6 screw to remove the FG harness from the
Low voltage power supply PCB ASSY.
(5) Remove the Taptite flat B M3x10 screw to remove the Inlet of the Low voltage power
supply PCB ASSY.
(6) Release the Hooks to remove the Power switch of the Low voltage power supply PCB
ASSY.
(7) Remove the Taptite bind B M4x12 screw.
(8) Release the harness of the Low voltage power supply PCB ASSY from the Guide of the
Main frame R ASSY.
Main frame R ASSY
Low voltage power supply PCB ASSY
Taptite bind B M4x12
Assembling Note:
• When assembling the Inlet, attach as shown in the figure below.
FG harness
Hook
Power switch
Screw pan
(S/P washer) M3.5x6
Fig. 3-36
2
1
Fig. 3-37
3-39
Low voltage power
supply PCB ASSY
Taptite flat B M3x10
Inlet
Hook
Inlet
Guide
Confidential