Advertisement
7. Provided in the packing kit with the tuner board is a cable labeled #32. Route one end
of this cable through the middle grommet as shown above, and plug one end into the
socket that you removed cable #31 from in step 6. Leave the other end unplugged. It
will be plugged into the autotuner board in a later step. Note that the space available to
reach in with your fingers to plug this cable in is limited. We recommend grasping the
connector end with a small pair of needle nose pliers to insert the #32 cable end into the
socket. Picture shown here is with the #32 cable successfully in place of #31.
Ten-Tec part #74431
Version 1 – February 2009
Advertisement
