Advertisement
6. Locate cable #31. This cable is labeled #31 at both ends. One end will be unplugged
by you in this step. The end to be unplugged is shown here, a white cable labeled 31, just
to the right of cable #23 and just above cable #29. With the radio right side up, these
cable ends are located in the middle of the right side of the low pass filter board that was
exposed after the tuner shield was removed in step 3. After unplugging the cable, pull
the unplugged end out from inside of the plastic grommet closest to the socket (shown
here with three additional black cables routed through the same grommet). This cable
will be plugged into the autotuner board in a later step.
Ten-Tec part #74431
Version 1 – February 2009
Advertisement
