Statistics Function; Making Coffee; Selecting The Coffee Taste; Selecting The Quantity Of Coffee In The Cup - DeLonghi ECAM22.360 Instructions For Use Manual

which remains as set).
1. Press the MENU button to enter the menu;
2. Press the or
played;
3. Press the button;
4. The message "Confirm?" is now displayed.
5. Press the button to confirm and exit.

Statistics function

This displays statistics relating to the machine. To display, pro-
ceed as follows:
1. Press the MENU button to enter the menu;
2. Press the or
played;
3. Press the button;
4. By pressing the or
- how many coffees have been made;
- how many times the machine has been descaled;
- the total number of litres of water delivered;
- how many times the water filter has been replaced;
- how many cappuccinos and milk based drinks have been
made (CAPPUCCINO).
5. Press then the

MAKING COFFEE

Selecting the coffee taste

The appliance is set by default to make coffee with a standard
taste.
you can also choose one of these tastes:
Extra-mild taste
Mild taste
Standard taste
Strong taste
Extra-strong taste
To change the taste, press the
edly until the required taste is displayed.

Selecting the quantity of coffee in the cup

The appliance is set by default to automatically deliver the fol-
lowing quantities of coffee:
- short coffee (≃40ml) when the
- long coffee (≃120ml) when the
- two short coffees when the
- two long coffees when the
To change the quantity of coffee the appliance delivers auto-
matically into the cup, proceed as described below:
- press and hold the button corresponding to the quantity
to be modified until "Program quantity" is displayed, then
button until "Default values" is dis-
button until "Statistics" is dis-
button you can check:
button twice to exit the menu.
button (fig. 7) repeat-
button is pressed;
button is pressed;
button is pressed;
button is pressed.
release the button;
- when the coffee in the cup reaches the required level, press
the same button again to memorise the new amount.
The machine is now reprogrammed with the new quantities.

Adjusting the coffee mill

The coffee mill is set by default to prepare coffee correctly and
should not require regulating initially.
However, if after making the first few coffees you find that the
coffee is either too weak and not creamy enough or delivery
is too slow (in drops), this can be corrected by adjusting the
grinding adjustment dial (fig. 8).
Please note :
The grinding adjustment dial must only be turned when the
coffee mill is in operation.
These adjustments will only be evident after at least 2 cups of
coffee have been delivered.
If this adjustment does not obtain the desired result, turn the
dial another click.

Tips for a hotter coffee

For hotter coffee, you should:
• before delivering the coffee, perform a rinse cycle by
pressing the
spout, heating the internal circuits of the appliance and
thus raising the coffee temperature.
• warm the cups by rinsing them with hot water (using the
hot water function);
• increase the coffee temperature in the settings menu
(page 10).

Making coffee using coffee beans

Important!
Do not use caramelised or candied coffee beans as they could
stick to the coffee mill and damage it.
1. Fill the container with coffee beans (fig. 9).
2. Place under the coffee spouts:
- 1 cup, if you want 1 coffee (fig. 10);
- 2 cups, if you want 2 coffees (fig. 11).
3. Lower the spouts as near as possible to the cup. This makes
a creamier coffee (fig. 12).
4. Press the button corresponding to the required coffee.
11
If the coffee is delivered too slowly or
not at all, turn one click clockwise.
For fuller bodied creamier coffee,
turn one click anticlockwise (do not
turn more than one click at a time
otherwise the coffee could be delive-
red in drops).
button. Hot water is delivered from the