How To Read Bar Codes With The Camera - Intermec CN51 User Manual

How to Read Bar Codes with the Camera

CN51 Mobile Computer User Manual
Camera Settings (Video) (Continued)
Setting Description
Hold record
Enable video stabilization
Enable video noise filtering
Enable video noise filtering
Frame rate
You can use the camera to read bar codes. When you read bar codes
with the camera, the computer treats the camera as it would any input
device, such as a Bluetooth scanner, and bar code data is sent to an
application as if it came from a scanner or imager.
Note: To read bar codes using the camera, you must use Intermec
Settings to configure bar code symbology decode settings.
There are two ways to enable reading bar codes with the camera:
• You can use the Profile Settings application to enable bar code
reading. The computer uses the current symbology decode settings
to read bar code data.
• You can configure individual parameters in Intermec Settings
(Data Collection > Camera > Scanner Settings) to enable bar
code reading.
Note: Parameters set in Data Collection > Internal Scanner >
Scanner Settings are applied to the internal imager, not the camera.
Chapter 4 — Use the Camera
Choices
When Timer mode is
enabled, this value is the
delay in seconds before
recording begins.
Check the box to enable
video stabilization.
Check the box to enable
video noise filtering.
Check the box to enable
video noise filtering.
•
15 fps
•
30 fps (default)
•
Custom. Adjust the
frame rate with the
slider.
65