６. Function; Power On/Stand-By; Volume Control; Switch Input Video - Clarion EA-2182E Owner's Manual And Installation Instructions

６. FUNCTION
1

Power On/Stand-by

CJ-7600 connection
2 Volume control (CJ-7600 connection)
❶
CJ-7600 connection
3

Switch input video

1) Basic screen switching
❶
CJ-7600 connection
Camera１
10
① Press POWER 「 」 button on monitor then the picture of the
camera will be shown on the monitor.
※ 「 」 Lamp is used when connected to the CJ-7600 monitor.
① Press and hold the ENT(VOL) button on the monitor to display the set volume and
② adjust the volume with the ▲／▼ buttons.
When using the remote control, the volume can be adjusted with the VOL+/-
buttons.
❷
※The volume cannot be adjusted on the Sub. display screen.
※ The volume is not displayed when an external monitor is connected. Adjust
the volume on the external monitor side.
① Press the AV button to switch to the AV (external
input) screen and press it again to return to the
previous screen.
② Press the ▲／▼ buttons in the AV (external in-
❷
put) screen to switch to the AV1/AV2 screen.
③ Press the ▲／▼ buttons in the camera mode
to switch the camera input. (The camera input
is switched in the reverse order with the ▼ but-
ton.)
※ The AV1 and Sub. display screen is displayed
only when the CJ-7600 monitor is connected.
※ The AV (external input) or screen for non-con-
nected cameras will turn blank.
→ →
Camera２
→
Camera３ Camera４
❷
❷
→
Sub.
❶