Clarion EA-2182E Owner's Manual And Installation Instructions page 15

Marker
Warning
- The onscreen distance markers should be considered as a general reference to assist the driver
in assessing the distances depicted on the screen. The distance markers have been designed
based on the back camera installation conditions listed in the next section, but differences in
vehicle design and construction may result in the actual installation condition or location be-
ing different from the conditions listed. In such cases, the display location should be set at the
closest marker No.
- Distance markers cannot be set if non Clarion cameras are used.
Caution
- The markers may not indicate the exact position of the bumper, the vehicle s width or the distance to
the rear. Use as a reference only.
1) Marker
① Select Marker in the Marker menu and press the ENT(VOL) button(OK or ▶ button on the remote
control).
② Select ON , OFF with the ▲／▼ buttons and press the ENT(VOL) button(OK or ▶ button on the remote
control).
※ Only when the distance marker is ON , the camera type and marker setting can be selected.
2) Camera type
① Select Camera type in the Marker menu and press the ENT(VOL) button(OK or ▶ button on the remote
control).
② Select 118° , 130° , 160° with the ▲／▼ buttons and press the ENT(VOL) button(OK or ▶ button on
the remote control).
※ If the camera angle of view is not in Camera type , select an object near the field of view to adjust it.
16
Marker
Marker OFF
Camera type １１８°
Marker type Type１
Up/down ０
L/R ０
Marker
Marker ON
Camera type １１８°
Marker type Type１
Up/down ０
L/R ０
Marker
Marker OFF OFF
ON
Camera type １１８°
Marker type Type１
Up/down ０
L/R ０
Marker
Marker ON
１１８°
Camera type １１８°
１３０°
Marker type Type１
１６０°
Up/down ０
L/R ０