Table of Contents
Advertisement
８.
CONNECTIONS
※ The monitor/camera/external remote control receiver shown in the
drawing are sold separately.
External remote control
receiver (CCA-712-500)
Connect to the main
AV2 （ Video ・ Audio)
Camera1
Camera2
Camera3
Camera4
※１ Use Clarion Cameras only.
※２ A camera connecting cable, sold
separately, is required for connecting
the camera.
■When the B/U terminal is connected to the car s B/U :
・When ACC is OFF, the shutter of the shutter camera closes automatically.
■When the B/U terminal is connected to the car s ACC (car with no B/U) :
• Even when ACC is OFF, the shutter of the shutter camera will not close automatically.
• To close the shutter, turn ACC OFF after setting the monitor to Standby .
• Make sure the B/U terminal is connected to the car s ACC together with the ACC terminal.
camera terminal
Input terminal
CAM/AV2
output terminal
（To external
monitor input
terminal）
Monitor connector
Recommended screws: Use φ5
tapping screws (4 units) that are
sold commercially.
Yellow(B/U): DC12/24V
Black(GND): Ground
Red(ACC): DC12/24V
Green (PARKING):
Connect to the earth line of the the parking brake lamp
Violet/White (TRIGGER 1):
Connect to the + terminal of the back gear lamp
Blue (TRIGGER 2):
Connect to the + terminal of the winker lamp
White (TRIGGER 3):
Connect to the + terminal of the winker lamp
Gray (TRIGGER 4): Connect to the + terminal of the
mode you wish to link to
Violet (REMOTE OUT):
Do not take away the insulation except during use.
CJ-7600 Monitor
23
Advertisement
Table of Contents
