Fisher & Paykel RS36A80J Installation Instructions Manual page 33

For toe kick installation higher than 4" (102 mm)
1
Measure the required height for the bottom grille. On a board, carefully score/cut
the un-required vanes from the bottom of the kickstrip grille and discard (refer to A).
2
Drill Ø 5/32" (4 mm) holes into the dimples of the grille (refer to B).
Repeat this process for all dimples.
Cut un-required vanes from the bottom of the grille
Grille tabs
3
With the grille tabs facing upwards, align the grille to the bottom of the plinth where the
screw holes are located and secure with screws x3 (#8 x ⅝ pan head screws) (refer to C).
Align the air flow divider underneath the grille tabs indicator and clip onto the vanes of the
bottom grille (refer to D).
DETAIL D
SCALE 2 : 1
3. USE PROVIDED SCREWS TO FIX GRILL TO
MATCHING HOLES ON PLASTIC PARTS
@0 ATTACH BOTTOM KICKSTRIP
SCALE 1 : 1
B SCALE 1 : 1
A
C
Front right view
DETAIL B
SCALE 2 : 5
D
For toe kick installation at 4" (102 mm)
1
With the grille tabs facing upwards, align the grille clips to the bottom of the plinth's slots,
DETAIL A
then firmly push grille onto the plinth (refer to A).
DETAIL A
1. IF TOEKICK IS HIGHER THAN 4" USE SIDE CUTTER TO
CUT UNREQUIRED VANES FROM DOTTOM
2. DRILL HOLES THROUGH DIMPLES
3. USE PROVIDED SCREWS TO FIX GRILL TO
MATCHING HOLES ON PLASTIC PARTS
2
Align the air flow divider underneath the grille tabs indicator and clip onto the vanes of the
bottom grille (refer to B).
DETAIL A A
SCALE 1 : 1 Grille tabs
DETAIL D
SCALE 2 : 1
DETAIL D
SCALE 2 : 1
DE
SCA
B
31