Fisher & Paykel RS36A80J Installation Instructions Manual page 24

5
Thread the free end of the water hose into the dedicated hole located in the base of the
appliance, through to the back of the appliance (refer to C).
6
At the back of the appliance, loosely coil the water hose (~2 – 3 times) and fasten the end of
the hose to the cold water supply (refer to D).
Take care not to over-tighten the connection. Turn the isolating faucet on and check that all
connections are dry and free of drips.
22
!1 CONNECT TO WATER AND ELECTRICAL SUPPLY
D
C
7
At the back of your appliance, connect the appliance to the electrical supply (115 VAC,
60 Hz) with the fitted plug and lead, and turn on. Ensure the appliance is connected to its
own isolating switch (refer to E).
Thread the excess power cord through the base, right hand side of the appliance to the front.
F
8
Gently push the appliance into position ensuring:
side tabs from installation aiders, contact the surrounding enclosure. Do not push beyond
● ●
contacting point;
the power cord is pulled through to the front base of the appliance (refer to F).
● ●
a firm contact is achieved between the appliance as it engages the anti-tip bracket,
● ●
2 3/8"min. (60 mm) overlap,
the water hose is tucked inside the base of the product to avoid damaging the hose.
● ●
Tuck the excess power cord neatly into the base of the appliance, and center the appliance.
E