Fisher & Paykel RS36A80J Installation Instructions Manual page 29

1
Remove the external display
module from inside the product.
Thread the display harness
through the door panel cavity.
Ensure the grommet is engaged.
2
Angle top display tabs into the
door panel. Ensure the harness
is free of pinching. Firmly push
against bottom display tabs
and insert into the door panel
until you feel it clip securely.
Ensure the display is flush with
the door panel.
3
Remove water tube from holder
on the refrigerator door.
4
Hang door panel onto M8 studs.
Ensure the panel is free to pivot
for water connections (refer to A).
!6 HANGING ICE & WATER DOOR PANEL
5
Connect display
harness onto the
refrigerator door by
inserting firmly until
you feel it clip securely
(refer to B).
On the external display,
enable the dispenser lock,
this will help prevent any water
from dispensing during water
connection. To lock, press the button
for 4 seconds. The LED above the
button will illuminate.
A
6
Firmly push the water tube into the
spigot behind the door panel until
the marked line is not visible.
Ensure the water tube is routed
away from any sharp objects,
sharp corners, and not in a location
where it can be kinked or squashed
when the door panel is secured,
(as this will stop water flow).
To secure door panel, follow the
instructions in the next section:
'Hanging non-Water dispensing
door panels'.
B
27