Dynamic Dns - Planet Networking & Communication ICA-M220 User Manual

Wireless Key
Self PinCode
Configure via Push Button
Configure via PinCode

3.5.3 Dynamic DNS

If your ISP does not give you a fixed Internet IP address (i.e. the Internet address you're using
when you access the Internet is not always the same – ask your ISP for detailed information), you
can use this function to help you locate the IP address of this IP camera when you're away from
home or office.
Before you can use this function, you'll need to apply for an account at dyndns.org
(http://www.dyndns.org). Detailed instructions of how to apply a new account can be found on
dyndns.org's website.
The descriptions of every setting in this menu will be given below:
Enable DDNS
Input the encryption key of selected wireless access point here.
This is required when access point you wish to connect uses
encryption.
Here displays the WPS pin code used to connect to WPS-enabled
wireless access points. You have to input this number into the
WPS enabled access point to establish WPS connection.
Click this button and this camera will enter PBC-style WPS
connection state for 120 seconds. Please push 'Start PBC' button
on the wireless access point you wish to connect within 120
seconds to establish WPS connection (The remaining time will be
displayed on the button).
If connection can not be established after 120 seconds, you'll be
prompted by a message box, and you can press 'Start PBC'
button to try again.
If you have wireless access point's WPS PIN code, you can input
it here and press Start PIN button to start to establish PIN-style
WPS connection.
Select Enable to activate Dynamic DNS function of this IP
camera, select Disable to disable it.
47