Table of Contents
Advertisement
3. Web-based Management Interface
This chapter provides setup details of the PT Internet Camera's Web-based Interface.
3.1 Introduction
The ICA-M220 / ICA-M220W can be configured with your Web Browser. Before configure, please
make sure your PC is under the same IP segment with PT Internet Camera.
3.2 Connecting to PT Internet Camera
Use the following procedure to establish a connection from your PC to the PT Internet
Camera.
Once connected, you can add the PT Internet Camera to your Browser's Favorites or
Bookmarks.
Make sure the IP camera is correctly powered (Power LED is on), and then launch Internet
Explorer and type the IP address of the IP camera in address bar of Internet Explorer. The Default
.
IP: http://192.168.0.20
You should be prompted to input the user name and password. Default username and password is
admin/admin. Click OK to continue after user name and password has entered.
If you're rejected, maybe the password has been modified previously. This should not happen if
this is a newly-purchased camera, however, if you get the camera from someone else, the
password would be changed. Please try to obtain the correct user name / password, or you'll have
to reset the camera.
33
Advertisement
Table of Contents
