Table of Contents
Advertisement
X . S E T U P & A D J U S T M E N T
D. BACKREST
The backrest comes standard with a 4"
height adjustment.
1. Height Adjustment
a) Remove the backrest upholstery from
the frame.
b) You will see the backrest tube which
telescopes into the frame and is secured
by a screw on the side of the frame.
c) There are four holes, 1 inch apart, you
may choose from to set the back height.
d) After selecting the proper height, slide
the backrest upholstery back on with
the overlap portion unattached.
e) Secure VELCRO
tubes and attach the excess overlap.
2. Back Angle Adjustment
(Folding Backrest)
An 8º (±5º) angle adjustment is standard
on this Quickie wheelchair.
a) Turning the eccentric bolt on the
backrest hinge plate will increase or
decrease the back angle.
b) The adjustment on each side of the
chair must be exactly equal.
E. SEAT SLING
The seat sling can be adjusted through the
use of VELCRO
beneath the seat.
1. Adjustment
a) Remove the screws retaining the left
side seat sling.
b) Re-adjust VELCRO
increase the tension in the seat sling.
c) Replace screws.
d) If there is any difficulty in reattaching
the screws, try using a probe to help
line up the holes.
F. CUSHION (OPTIONAL)
1. Installation
a) Place cushion on seat sling with
VELCRO
®
side down.The beveled edge
of the cushion should be in front.
b) Press firmly into place.
®
style material on side
®
-style retaining material
®
- style material to
33
930301 Rev. C
Advertisement
Table of Contents
