Amped Wireless HIGHPOWER AC1750 Setup Manual page 42

WDS Settings
WDS - Bridge mode requires additional Access Points also
functioning in WDS - AP mode. A WDS enabled Bridge
connects to another WDS-Access Point via MAC addresses.
Enter the MAC addresses of the Access Points with WDS
enabled into the corresponding fields that you wish to connect
to.
For WDS connections to work properly, the MAC address
associations must also be configured on each individual WDS
enabled Access Point or Bridge, not just the one you are
currently configuring. For example, if you are connecting three
WDS APs or Bridges, AP/Bridge 1 must have AP/Bridge 2 and
AP/Bridge 3's MAC address conifgured, while AP/Bridge 2 has
AP/Bridge 1's and AP/Bridge 3's MAC, and AP/Bridge 3 has
AP/Bridge 1's and AP/Bridge 2's MAC configured.
Encryption can be used to secure your WDS connections. If you choose to use encryption (recommended), it is
important that you set the same security key setting on all connected WDS enabled Access Points. Click Next to
continue.