Table of Contents
Advertisement
Operation
When the switch is in the center
(" O ") position the unit is off.
B. Heat On/Off Switch
The Heat On/Off Switch supplies
power to the heater fan and the
heater element.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the
3-Position Switch to Off and
waiting five (5) minutes before
switching the unit back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).
Remote Control
The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one
of hundreds of independent
12
frequencies to prevent
interference with other units.
!
NOTE: Ensure that the
fireplace's 3-Position Switch
is set to the remote control
setting (" II " position).
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace off.
!
NOTE: Before attempting
any operation with the
remote control, pull the
plastic insulator strip out from
between the remote casing
and battery cover (Figure 8).
Remote Control Initialization/
Reprogramming
In the event that your remote
control ceases to operate your
fireplace, follow these steps to
re-initialize the remote control and
the remote control receiver in the
fireplace:
1. Place the 3-Position Switch
(Figure 7A) in the Off (" O ")
position.
2. Wait a minimum of five (5)
seconds and then place
the 3-Position Switch in
the Remote Control (" II ")
position.
3. Within 10 seconds of
www.dimplex.com
Advertisement
Table of Contents
