Menu Configuration; First Time Installation; The Operation Procedure - JVC DT-E15L4 Instructions Manual

Menu Configuration

First Time Installation

When you turn on the power and the monitor, "First Time Installation" appears.
Start setting referring to the menu configuration.
For the setting items, see the pages below.
☞ "Language" on page 38
• "Language"
☞ "Sync Function" on page 35
• "No Sync Action"
☞ "No Operation Action" on page 35
• "No Operation Action"
Setting procedure
1
Press to move the cursor to the setting item
2
Press to select the setting values
●
Each time you press one of these buttons, the setting value changes.
3
Move the cursor to "Set"
4
Press to finish setting
●
When you change the settings, a confirmation message appears.
Operate according to directions.

The operation procedure

1
Press the MENU button to display the Main Menu
To display the Main Menu
➡ Press the MENU button.
To display the Set-Up Menu
➡ Press the
button while holding the
2
Use the buttons to select an item and press the
proceed to the next screen
3
Use the buttons to select an item and press the
proceed to the next screen
●
For some items, pressing the
4
Use the buttons to select an item and use the
to adjust the setting
5
Press the MENU button to finish operations
●
Press the MENU button repeatedly until the menu screen disappears.
30
button.
button to
button to
buttons adjusts the setting.
buttons
●Once the settings have been adjusted, this screen
will not appear again.
●The settings can be changed afterwards in Main
Menu and Set-Up Menu.
Main Menu
Selected item
Operation
●
The menu screen disappears automatically if no operations are
made for about 30 seconds.
●
Inoperable menus will be grayed out.
●
Some items will not be displayed on the menu depending on the
selected input and signal format.
Set-Up Menu
guide
Ex.: When "Picture Function"
in the Main Menu is selected