Table of Contents
Advertisement
Available languages
Available languages
8 AUDIO (MONITOR OUT) terminals (pin jack)
Output terminals for the analog audio signal.
●
The terminals emit the audio signals through the AUDIO (IN) terminal or EMBEDDED AUDIO signals through the E. AUDIO HD/SD SDI (IN 1
or IN 2) input terminal.
●
The signal is output from this terminal only when the monitor is on or in "Power Save" (power save) mode (☞ "No Sync Action" on page 35).
●
The EMBEDDED AUDIO signal...
–
is decoded into an analog signal, then emitted.
–
is emitted only when "SDI 1" or "SDI 2" is selected, and when EMBEDDED AUDIO signals come in to the E. AUDIO HD/SD SDI (IN 1 or IN 2)
terminal.
●
Audio signals are only output from the HDMI terminal when the signals are not protected by HDCP.
–
Even when the signals are protected by HDCP, sound is emitted from the speakers.
9 POWER switch
Turns AC power on or off.
●
You need to press
p AC IN terminal
AC power input connector.
Connect the provided AC power cord to an AC outlet.
CAUTION
Do not connect the power cord until all other connections are completed.
Note for connections
•
Before making any connections, turn off all the equipment.
•
Use a cord whose plugs correctly match the terminals on this monitor and the equipment.
•
Plugs should be firmly inserted; poor connections could cause noise.
•
When unplugging a cord, be sure to grasp its plug and pull it out.
•
DO NOT connect the power cord until all connections are complete.
•
Refer also to the user manual of each piece of equipment.
button (☞ u on page 28) to use the monitor after turning on the POWER switch.
27
Advertisement
Table of Contents
