Turning The System On; Inserting/Ejecting A Disc; Inserting The Disc; Removing The Disc - Alpine X009E Owner's Manual

Turning the System On

With the Alpine system, when the ignition key is turned to ACC or ON,
the opening screen will be automatically displayed.
1
When the system is used for the first time, the
language selection menu is displayed. There are 24
languages to choose from. Touch [
scroll the list, and then touch the desired language.
• You can also scroll through lists by touching the screen and
sliding your finger up and down.
2
Touch [OK].
The radio screen is displayed.
• Some of this unit's functions cannot be performed while the vehicle is
in motion. Be sure to stop your vehicle in a safe location and apply
the parking brake before attempting these operations.

Inserting/Ejecting a Disc

Inserting the Disc

1
Press c (Eject).
The Open/Tilt screen is displayed.
2
Touch [c Disc].
3
Insert the disc with the label side facing up.
SD memory
card slot*
Insert the disc until it is automatically pulled into the unit.
The unit starts to play the disc.
* The SD memory card does not support Music/Video playback.
For details on how to use SD memory cards, refer to "Navigation
system OM".
• To remove the SD memory card, touch [
• Insert the SD memory card into the slot until it is locked.
If the SD memory card is not inserted properly, the monitor cannot be
closed.
18
-EN
] or [ ] to
Disc Slot
SD].

Removing the Disc

1
Press c (Eject).
The Open/Tilt screen is displayed.
2
Touch [c Disc].
The monitor will open. Then the disc is ejected.
When the disc has been ejected part way, take it out.
• Even if no disc is inserted, the monitor will open after touching
[c Disc].
3
Touch [Close], or press any button.
• If the disc does not eject after touching [c Disc], press and hold
c (Eject) for at least 5 seconds.
• Do not apply shock to the monitor when it is open as it may result in
malfunction of the unit.
• The monitor will stop at the set tilt angle when closing.
CAUTION
Keep hands (or any other object) away from the monitor while it
is opening or closing to avoid damage or injury. The back of the
monitor tends to become very warm under normal operating
conditions. This is not a malfunction, but care should be taken to
avoid prolonged contact with it.

Adjusting the Screen Viewing Angle

Adjust the screen's angle for better visibility.
1
Press c (Eject).
The Open/Tilt screen is displayed.
2
Touch [ U] or [ Down] of "Tilt" to adjust the
desired screen angle.
The screen angle can be adjusted in 5 stages.
3
Touch [ ] to return to the normal mode.
• The screen colour will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.
• If the voltage of the vehicle's battery power is low, the screen may
blink when the screen angle is changed. This is normal and not a
malfunction.

Adjusting the Volume

Adjust the volume by pressing
Volume decreases/increases continuously by pressing and
1 2
holding , (or -,+) .
* *
Volume: 0 - 35

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
1
1
Press MUTE (or
*
The audio level will decrease by about 20 dB.
2
1
Pressing MUTE (or
*
back to its previous level.
1
* For Alphard/Vellfire
2
* For Estima
1 2
, (or -,+) .
* *
2
) to activate the MUTE mode.
*
2
) again will bring the audio
*