Alpine X009E Owner's Manual page 95

Connection of an External device
CAMERA/W.REMOTE Connector
AUX/PRE OUT Connector
Power Supply Connector
AUX/PRE OUT cable
REMOTE IN
(Brown)
REMOTE OUT
(Brown)
MIX CONT
BEEP/NAVIRG
1 Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
2 Remote on Lead
3 RCA Extension Cable (sold separately)
4 Front Output RCA Connectors
RED is right and WHITE is left.
5 Video/Audio Input Connectors (AUX INPUT)
Video/Audio Output Connectors (AUX OUTPUT)
Used when connecting an optional monitor, etc.
Remote Control Input Lead (Brown)
Connect this lead to the remote control output lead. This
lead inputs the controlling signals from the remote control.
Remote Control Output Lead (Brown)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
1
* When a fiber optic compatible external audio processor (PXA-H800, etc.) is connected, the External AP and Optical should be set to On. Refer to
"Setting the External Audio Processor On/Off" (page 42) and "Setting the Digital Output" (page 42).
2
* When a fiber optic compatible external audio processor (PXA-H800, etc.) is connected, the power supply of the built-in amplifier is stopped and an
external amplifier should be used to drive speakers. For details, refer to the owner's manual of the compatible external audio processor.
• You can change the name of an external device. Refer to "Setting the AUX Mode" (page 51).
Optical Digital Cable (KWE-610A) (Sold separately)
To Audio Input terminal
(Red)
(White)
To Video Output terminal
(Yellow)
(Red)
(White)
To Audio Output terminal
To Video Input terminal
(Yellow)
(Red)
(White)
To Audio Input terminal
MIX Control Lead (Green/White)
Use when an optional External Audio Processor with guide
control input terminal is connected.
• When this lead is connected to PXA-H800, make sure to
turn the ignition key off (ACC OFF) and on (ACC ON)
again or turn the unit power off and on again, after setting
"Navi Mix" from OFF to ON on PXA-H800.
Beep/NAVI Guide Connector
Output the audio signal of navigation interruption.
When connecting an Audio processor, connect this lead to
the Guide Input terminal with an optional RCA Extension
cable.
Navigation audio input connector (RCA input) (NAVI)
Used to input the audio output signals of a navigation
system.
To Fiber optic digital Input
terminal (for head unit)
Audio Processor (Fiber optic
digital compatible) (PXA-H800,
1/
etc.) (sold separately)*
DVD Changer (sold separately)
Rear monitor (sold separately)
REMOTE OUT
(White/Brown)
REMOTE IN
(White/Brown)
Guide Control
2
*
95
-EN