Troubleshooting - iHome Kineta iKN150 Instruction Manual

Unit doesn't respond (no power)
• Check that unit is fully charged OR connected to AC power.
• Make sure your device is properly paired with the K1.
• Make sure the Power is ON.
• If the unit seems "frozen" or locked up, insert the end of a paperclip or similar into the Reset button
under the jack cover on the left of the unit to reset unit.
Resetting Bluetooth
If Bluetooth function is not operating properly, you may wish to reset Bluetooth. To do so, press and hold
the Bluetooth Button 10 seconds. You will hear a long high tone. You will then need to re-pair any
previously paired devices.
K-Cell Won't Eject
If the K-Cell won't eject even after pressing the K-Cell Eject Button, turn the unit over and insert the end of
a paper clip or similar at a slight angle into the Battery Release pinhole port located on the bottom of the
unit.
Trouble pairing device/computer with K1
Bluetooth implementation varies depending on your device's hardware and operating system. Please see
our website for updates on pairing.
• Make sure you have the latest firmware for your device.
• Make sure your device is working properly. Check your device's manual for details on Bluetooth pairing
and linking.
• When you power ON the speaker, it will automatically link with the last previously paired Bluetooth
device if the device is still within range (approx.30 feet). To pair with a different device you must turn off
Bluetooth capability on the already paired device, or take it out of range.
For further information and to see the latest instructions, visit www.ihome.com/support
15

Troubleshooting