NOTE: Be careful not to touch the surface of the speakers at either end of the unit Getting Started Thank you for purchasing the iHome iC16 Audio Speaker System for your Android. Designed specifi- cally to work with your Android device, this system provides high quality audio performance that brings out the best in your music.
Page 3
FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Controls and Indicators Top Panel Button Raise volume, Adjust Clock Adj. Button Snooze/Dimmer Button clock/alarm time forward Press and hold for Silence alarm temporarily Clock Adjust mode or adjust display brightness Button Lower volume, Adjust clock/alarm time backward Power Button Press to power unit ON or OFF Alarm Button...
Quick Start 1:power 2:Android RESET R TEST T Connect one end of the included Attach the AC adaptor cable to stereo audio cable with 3.5 mm plugs the AC adaptor jack on the back to the headphone jack on your of the iC16 and plug the other end Android device and the other end to into a working wall socket.
iC16 Display Snooze Indicator Daylight Saving Time Indicator Battery Low Indicator Audio Indicator Alarm Indicator PM Indicator Time Display Install Clock Backup Battery The iC16 uses a CR2032 button cell battery (included with instructions) to keep alarm and clock settings in the event of a power failure and 4 “AA” batteries to maintain alarm operation.
Using iC16 Install AC Adaptor Connect the AC adaptor cable plug into the AC adaptor jack on the back of the iC16, then plug the AC adaptor into the wall outlet. RESET R TEST T Installing/Replacing Batteries for Portable Operation The iC16 uses 4 “AA”...
Listening to Your Android 1. Connect the included stereo audio cable to the output/headphone jack on your Android and the other end to the aux in jack located on the back of the unit. 2. Press the Button on the iC16. The Audio Indicator ( ) appears in the display. 3.
Alarm Operation Note: In order for the alarm to operate you must install the 4 "AA" batteries or have the AC adaptor connected. The CR2032 back up battery will maintain the time and alarm settings but it will not turn on the alarm.
Snooze/Dimmer Operation Programming Snooze Time The default snooze time is 9 minutes. You can adjust the snooze duration. During normal operation (when alarm is NOT sounding), press and hold the Snooze/Dimmer Button for 2 seconds until the ZZZ indicator and Snooze time display flashes. Adjust the duration of snooze time up or down (between 1 - 29 minutes) by pressing the Buttons.
A Consumer Guide to Product Safety IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference.
Trouble Shooting Symptom Possible Problem Solution Unit doesn’t AC adaptor isn’t plugged into a Plug the AC adaptor into a wall outlet and plug wall outlet or the connector is respond the connector into the supply jack on the unit not plugged into the power (no power) supply jack on the back of the...
Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of One Year from the date of original purchase.
Need help?
Do you have a question about the SMARTDESIGN iC16 series and is the answer not in the manual?
Questions and answers