Power Control System (Pcs); Furnace - Propane Gas - Winnebago Sunova Operator's Manual

• Lift handle straight out to open P-T valve
when water heater is cold.
-Typical View
4. Let the handle of the P-T valve snap shut.
5. Close the faucet and turn on the water supply
before switching the water heater on.
Manually operate the pressure temperature
relief valve at least once a year.
NOTE: If your water heater is equipped with the
motoraid system, it uses an extension
from the engine cooling system to heat
water in the water heater while driving.
The engine cooling system must also be
cold before opening the pressure-
temperature relief valve. See "Motoraid
Water Heater" for more information.
POWER CONTROL SYSTEM
(PCS)
–If Equipped
The Power Control System (PCS) monitors
the electrical usage of the appliances and
equipment in the coach and allows you to use
certain high energy appliances, such as the
microwave or washer/dryer, without overloading
the shoreline circuit breaker to help prevent
nuisance tripping.
APPLIANCES AND SYSTEMS
PCS Display Panel
(Located near monitor panel)
-Typical View
Further Information
Refer to the manufacturer's user guide
provided in your InfoCase for important
information on how this system operates under
several conditions, whether 20-amp, 30-amp, and
50-amp connections, or generator service.
NOTE: In 50-amp service, the load meter is
blank. In all other conditions, the load
meter displays actual current load.
FURNACE – PROPANE GAS
To Start Up
1. Open the Propane Gas Tank valve by turning
fully "counter-clockwise".
Thermostat Switch
• Move to Heat or Gas
position for furnace
operation
-Typical View
SECTION 4 –
Temp Selector
• Press up or
down to select
temperature
4-11